GN Decanter Centrifuge for Diamond & Core Drilling Application

GN Solids American is committed to protect environmental and compliance to environmental discharge regulations. Especially in drilling fluids recycling application, GN solids control equipment could maximum recovery the drilling cuttings and reclaim the fluids. GN small decanter centrifuge is mainly used for diamond & core drilling industry to remove fine solids in the fluids.

GN decanter centrifuge combining with other solids control units makes a complete dewatering system. In the remote drilling site, our dewatering system allows drilling contractor to reduce the amount of waste water and water transported. The complete dewatering system can fully recycle contaminated drilling fluids and reclaim the clean water. Shale shaker works as the first stage to kick off big and aggressive particles. GN decanter centrifuge is normally installed in the end of dewatering system to remove the fine solids and obtain the clean fluids. Here some reason why many drilling company choose GN centrifuge.

Advantage of GN Small Bowl Centrifuge

1. GN diamond & core drilling decanter centrifuge is a 9” bowl centrifuge very small footprint suiting in the constrained drilling place.

2. 3800RPM is capable of removing 2~5 microns solids in the fluids. We also offer the fixed speed control panel, Variable Frequency Drive（VFD）control panel , standard motor and hydraulic motor to meet or exceed customer expectation.

3. We use high standard duplex stainless steel to fabricate the centrifuge, and top quality and durable bearing are also installed in the decanter centrifuge.

4. GN centrifuge can efficiently remove finer solids and control the weight or density of fluids so it obviously improves ROP.

Except the diamond & drilling application, GN centrifuges are also utilized in the oil & gas drilling fluids industry. We have 14”, 18” and 22” bowl centrifuge to meet with different requirement. Contact with GN to get more information.