• Twitter
  • Facebook
  • Google+
  • LinkedIn
  • YouTube

Products

Contact Us

GN Solids America LLC

Tel:+1 (713) 320-3868

Email: This email address is being protected from spambots. You need JavaScript enabled to view it.

Add:6710 Windfern Road, Houston, TX 77040,USA

 



Hydrovac evacuation is a new method to route cables and underground utility pipelines in cities. Its main advantage is non destructive, it would not hurt the facility underneath. Also it is high efficient, it cuts the ground open in a few minutes contributed to the high pressure of water spray in the form of “water knife”.


As is always the case, everything has two sides. This applies to hydrovac evacuation as well. This process generates a lot of mud.


Many local governments forbidden the dumping of such mud freely, it must be separated into soil and water. They also put strict requirement on the quality of water.


Many manufacturers turn out dewatering system to meet such requirement. This is especially true to the manufacturers in North America, which are priced at a few million USD.


GN Solids Control, being one of the major manufacturers for equipment of solids control, separation and conveyance, releases its dewatering system to the market as well. However, almost all of its customers were astonished with the price of GN dewatering system, which is only a fraction of those systems manufactured in NA.


As a matter of fact, it is the natural result of the following reasons.


1. High efficiency of China supply chain
This is due to the high density of bullet trains, well-coordinated courier system and application of new technology in the supply chain in China


2. Highly competitive market in China
This tremendously lower the price of everything from screw to huge lathe. For instance, GN Solids Control uses duplex stainless steel for the bowls of its decanter centrifuge, other manufacture may use stainless steel 304


3. High efficiency of GN Solids Control’s manufacturing process
GN Solids Control introduced highly efficient manufacturing systems to increase manufacturing efficiency


4. Introduction of self-programming technology in automation and control
This is a new technology which can generate PLC logics automatically, which greatly cut the cost of programming and the customer of GN Solids Control can benefit from it

 

Contact Us

Fields marked with ( * ) are required.

 
×

Contact us

By submitting this form, you accept our privacy policy.
×

Login

  or   Create an account

Forgot your password? |  Forgot your username?

×
×

WS Register



  or   Login
×

Subscribe to Our Newsletter

×